Factory for sugar extraction from sugar beets, with a daily capacity of 2.000 tons of raw material. Fully equipped factory with a few years of operation.

LIST OF PROCESSING EQUIPMENT

   1. Diffusion Station
          * Continuous diffuser RT 2. Rotary drum of 5.15 m in diameter and 32 m in length. With 32 cells of 1.00 m in width. Controlled speed engine.(2) sand collectors of 1.8 x 0.7 m. Formalin measuring pump. Section control and command electrical panel.
   2. Juice Purification
          * Carbonating machine I of 2.40 m in diameter x 8.00 m in height, with PH automatic controller.
          * (2) DORR decanters. Each with three diaphragm pumps.
          * (4) rotary vacuum filters, each of 20 m2.
          * Vacuum system for the filters consisting of:.
          * Reverse current compensator of 1.00 x 2.30 m, and (2) water ring vacuum pumps of 2.200 m3/h.
          * Low-pressure thickener filter with mesh for bleached juice of 50 m2.
          * Remote control valves.
          * (11)carbonating machines of 2 m in diameter x 8 m in height,with pumping
          * tank of 3 m in diameter x 6.5 m in heigth, with PH automatic control.
          * (4) low pressure thickener filter of 50 m2. Remote control valves.
          * (3) thickener filters for bleached juice II, of 50 m2. Remote control Valves.
          * Central control panel for the purification system.
   3. Evaporating Station
          * Evaporation consisting of:
          * Stage I: one body of 1.200 m2, 3.4 x 10.93m.
          * Stage II: two bodies of 800 m2 each and 3.20 x 10.37 m each.
          * Stage III: one body of 1.200 m2, 3.40 x 10.93 m.
          * Stage IV: one body of 800 m2 and 3.2 x 10.37 m.
          * Level control for evaporators.
          * (5) Niessner systems for condensation.
          * Level control system of evaporators and condensers.
   4. Crystallization and Centrifuging
          * (7) units: vacuum baking devices for A, B, or C product with 250 m2 of heating surface and 50 tons of load capacity each, steel pipes of 102 x 3.5 mm with widened juice chamber, with crystaloscopes and control panel. Diameter 3800/4400 mm. Hydraulic system for control valves.
          * Crystallizers/receivers for A, B, C baked mass of 2.4 x 8.5 m, with a Product capacity of approximately 50 tons.
          * 14 units: centrifugals for A or B product of 1.250 mm in diameter and 500 kg of mass at 960 RPM, with distributor/mixer. Includes syrup collecting system; fumes extractor of 400 m3/h, with syrup recapture, vibratory chute for white sugar. Three of these units for C product refining at 1.450 RPM.
          * The crystallization and centrifuging process described above also includes All the necessary centrifugal or rotary piston pumps, air compressors, conveyor belts and tanks.
   5. Sugar Drying - Sugar dryer/cooler with rotary drum. Consisting of:
         1. Cell locks for input and output of sugar of 350 mm.
         2. Radiator for 60.000 m3/h y 760.000 kcal/h.
         3. (4) air filters of 16.000 m3/h.
         4. Centrifugal fan from 55.000 to 60.000 m3/h.
         5. Wet dust removal plant, with cyclone, 12 nozzles of 4 l/min each and (2) pumps of 300 l/min at 40 m.
         6. Dissolution tank with shaker and 2 pumps of 300 l/min at 25 m.
   6. Condensation and Water Supply - Barometic condensers for fumes consisting of:
          * Vacuum condenser for baking decives of A product and evaporation, 1.600 mm diameter x 4.500 mm in height.
          * Condenser for vacuum baking decives of B and C produst and evaporation 2.000 in diameter x 5.000 mm in height.
          * Drop separator traps of 1.80 x 2.10 m.
          * Two condenser centrifugal pumps for water of 16.700 l/min at 40 m.
          * Four water ring vacuum pumps of 2.000 m3/h each.
          * Ponds for barometric foot.
   7. Lime Plant
          * Induced draft vertical lime furnace. External diameter of 3.80 x 29.70 m In height, 120 m3. Load device with stoker lock, lime extractor device with hopper, platforms, ladders, etc.
          * Carbon dioxide extraction system consisting of:
                o Washer/cooler of CO2 gas of 2.00 x 5.50 m
                o Water separator of 0.62 x 2.40 m
                o Pipes for CO2 of 600 mm in diameter.
                o (4) water ring CO2 compressors, 2.000 m3/h each.
                o Pressure containers for CO2.
                o Pressure control system for CO2.
                o Lime slake pant, consisting of:
                o Lime dosing flume of 12.50 m
                o Elevator buckets of 0.40 x 7.60 m
                o Lime slaking drum of 1.60 x 8.00 m
                o Pierced base screen of 0.75 m2
                o (2) centrifugal pumps for whitewash of 300 l/min at 45 m.
                o (6) hydro-cyclones to remove particles from whitewash of 1.00 m in diameter.
                o Container for filtered whitewash of 1.60 x 3.85 m, emptied by shaking pump.
                o Collector and conveyor system for particles separated in hydro-cyclones.
   8. Drying Plant - Dryer plant with liquid fuel consisting of:
          * Helicoidal rotor pump of 70 l/min at 30 bar
          * (12) dual filters of 7 m3/h each
          * (12) rotary diffusers of fuel of 2.200 kg/h
          * Combustion chamber
          * Fan for combustion chamber
          * Dryer drum with discharge box and emptier of 3.00m in diameter x 15.00m length, Consisting of:
                      o Aspiration pipes between drum discharge box and centrifugal fan.
                      o Centrifugal fan of bilateral aspiration of 180.000 m3/h
                      o (2) cyclonic separators of dust, of 3.90 m in diameter and 3.00 m in height.
                      o Worm conveyors, one of 0.50 x 13.25 m and one of 0.32 x 6.50 m.
                      o Molasses adding plant, consisting of:
                      o Settling bucket and heating of molasses.
                      o Dosing container of 0.60 x 0.70
                      o Pump for molasses.
                      o Double chamber filters for molasses.
   9. Pellet Production
          * Pellet press type Herba 2/600, with engines of ....c.c. of .....kw each.
          * Shaker screens to refine and separate pellets and carry them to cooler.
          * Vertical cooler for pellets, consisting of fan and cyclonic separator of 1.80 x 1.20 m, with rotary cell valve.
  10. Steam Plant – Boilers
          * (3) fuel pumps of 25 m3/h each at 10 bars of pressure.
          * (3) water tube boilers of reheated steam. Fuel-oil. Mazimum continuous production of 25 tons/h each, design pressure of 27 bars, steam exhaust at 360º C. Consisting of:
                o Tubular heater for combustion air
                o Feed-water heater with winged steel pipes.
                o (2) rotary burners for Engler fuel.
                o Fuel heater with pump and filter.
                o Air heater with steam heating.
                o (3) feed-water pumps with a capacity of 1.050 l/min at 35 bars, with water at 120ºC. Two of them electric and one with steam turbine. One electric engine centrifugal pump for starting boilers, with a capacity of 333 l/min at 35 bars.
          * Chemical processing of feed-water consisting of:
                      o (2) product dosimeter
                      o (2) fine filters
                      o (2) water softeners, with feedback containers with brine.
                      o Chemical feed-water processing:
                      o Feed-water tanks, soft for water reserve and condensed for sugar plant.
                      o (2) degasifiers, one for drinking water and one for condensed at a rate of 40/50 tons/h.
  11. Electrical energy plant – turbo alternator
          * (2) turbo-alternators of 3.000 kW each, turbines of 6.000 RPM with reducers at 1.500 RPM for the alternator, consisting of:
                o (2) Corlitzer Machinenbau Gmbh turbines, steam input pressure:
                o 24 bars and 355ºC temperature, backpressure: 3.2 bars +/- 0.5 bars. Consisting of:
                      + Steam filter with water trap
                      + Steam quick lock valve
                      + Speed controller
                      + Auxiliary ail pump with filter
                      + Oil cooler
          * (2) Sachswerk (Dresden) generators, of 3.750 kva, cos phi 0.8 effective power at room temperature of 45ºC, 6300 volt; 50 Hz; 344 Amperes; 23 kW exciting power; 115 volts.
          * Diesel electrical generator of 375 kw, 400 volt, 50 Hz. Four-stroke vertical diesel engine.
          * Electric panel to control turbine and for control and distribution of electrical energy among the different section of the plant. External energy sub-station.

ALSO INCLUDED: The following have been omitted from the above description due to their large quantities: all the pump systems, conveyor belts, measuring devices, heat interchange devices, and all the necessary equipment for processes like packing, weigting, laboratory, tanks, chutes, valves, pipes, storage etc.

 

request more info.